GOLDEN Silverpoint / Drawing Ground is a liquid acrylic used for the preparation of supports for drawing media. The ground is designed for the achievement of fine detailed lines on a permanent, lightfa...+ Show More
GOLDEN Silverpoint / Drawing Ground is a liquid acrylic used for the preparation of supports for drawing media. The ground is designed for the achievement of fine detailed lines on a permanent, lightfast, flexible ground. Silverpoint / Drawing Ground is ideal for use with metal styli or other drawing tools. The Silverpoint / Drawing Ground is formulated with 100% acrylic polymer emulsion. It is a low viscosity fluid that contains high levels of titanium dioxide and prepares surfaces to readily accept marks from a metal stylus.
GOLDEN Silverpoint / Drawing Ground is designed for thin applications only. When applied too thickly the film may crack upon curing. A single thin coat is typically sufficient.
It can be brush or spray applied to paper, primed canvas, wood or any surface that will accept a water-based coating. The most common substrate for metal point drawing is heavy weight hot pressed watercolor paper.
Note: Because lower weight papers are susceptible to buckling from the moisture in the Silverpoint / Drawing Ground, some artists may find taping the edges down will help prevent extensive warping.
-Shake container thoroughly before use as the thin viscosity and high pigment load is prone to settling.
-Open jar and allow to sit for a minute or two to allow some foam to dissipate.
-Pour the quantity needed to coat substrate into a wide flat dish slightly larger than the brush to be used.
-With a soft brush apply Silverpoint / Drawing Ground in even strokes, working from one side to the other and keeping a wet edge
-Brush back over any area where foam is evident in order to dissipate remaining bubbles.
– Allow to cure 24 hours
No additional thinning is necessary and most spray equipment can be used
Silverpoint / Drawing Ground can generally be tinted with a maximum of 15% GOLDEN Fluid Acrylics without negatively affecting its performance. Alternatively, Golden's Airbrush Colors or High Flow Acrylics can also be used up to the same 15% maximum; as these products are closest in viscosity to the Ground, there should not be a noticeable change in thickness.
Metal Stylus Selection
The term Metal Stylus may be interpreted very broadly. In essence any metal object that will leave a mark on the surface of the Silverpoint / Drawing Ground is acceptable. The hardness of a metal object defines the darkness of the initial metal mark as softer metals allow for more metal particles to be transferred during initial mark making. Over time metals that oxidize will become darker and potentially change color i.e. silver will become very black while copper will turn slightly green.
Lastly, Silverpoint / Drawing Ground may be painted over with acrylic paints as well as applied onto already painted surfaces.- Show Less
You May Also Like